DG9MAQ

Homepage
Sitemap
Home-Rig
VHF-/UHF-DX
Mobile-Rig
Links






What is "Amateur-Radio " ?










My VHF-/UHF-DX Location









Member

I'm a Member of the following Organisations:

DARC OV Schmuttertal DOK T20 Link 

DIG Diploma-Interests-Group Link 
DL-QRP-AG Link
 




 

QTH of my two fixed Radio-Stations 

I'm active from two fixed Locations.

The first Location:
Here i do only QRP on Shortwave and some local QSO on 2m/70cm-Band, because the Antennasituation is not the best.

The second Location:
Here i do the VHF-/UHF-DXing with good Antennas for 2m and 70cm. There is also a Wire for Shortwave under the Roof.
Both QTH's are located in the Grid-Square JN58LJ Link .



VHF-/UHF-DX at my 2nd-QTH

Here i use a YAESU FT-736R for 2m/70cm/23cm-Band, homemade CAT-Interface, dynamic Microfon YAESU MD-1 and a Power-Amplifier made by HA8UG - Amplitec Link , Model UG2-30/500 with a Tube GI46b for 144 MHz Link
Here you can see some Pictures from inside the Amplifier Link



For 70cm i use a PA from SSB-Electronic with max. 100 Watts Output. The Antennas are a 9 Element Cross-Yagi from Tonna/F9FT, a 11 Element Flexa-Yagi for 144 MHz and a 19 Element Cross-Yagi from Tonna/F9FT. The Cross-Yagis are about 12m over the Ground. On Top of the Mast is a vertical Groundplane for 144 MHz.
Preamplifiers from SSB-Electronic, SP-2000 and SP-7000 make me able to hear the Grass growing. For switching the PA and Preamplifier i use a Sequencer from SSB-Electronic "DCW 15B".


QRP at my 1st-QTH

Here i use a Diamond X-30 Groundplane for 2m and 70cm local QSO. The Transceiver is my 30 Years old ICOM IC-251E with 10 Watts Output on 144 MHz in all Modes. The Microphone is a electret Condenser Type ICOM IC-SM5. A little GaAsFET-Preamlifier DAIWA RX-110G make the weak Signals louder. A DAIWA SWR-/Power-Meter CN630 gives me the information of the Output.

On Shortwave, mostly 20m-Band i do QRP with the KENWOOD TS-50S and a dynamic Microphone. The Antenna for 20m is a 0,56m short MICROVERT (designed by DL7PE, made by DG9MAQ). I use a "Super-MWS" designed by DL7PE, made by DG9MAQ also. For 40m sometimes i use DL7AHW's "Can-Tenna".

Better QRV with less of High-Frequency than not !



 
Home | Kontakt | Impressum